LG 65EE5PC Owner's Manual page 4

4
• Do not leave the power or signal cable, etc. in walkways.
- If you step on or fall over the cable, it may cause fire, electric shock, product damage or personal injury.
• Do not use the product in a damp place such as a bathroom where it is likely to get wet.
- This may cause fire, electric shock or product malfunction.
• Do not insert pieces of metal, such as coins, hairpins and metal debris, or flammable materials, such as paper or
matches, into the product. In particular, make sure that children are instructed to follow these instructions.
- Attempting repair or modification yourself may cause a fire hazard or result in electric shock. If foreign materials fall
into the monitor, disconnect the power cord and then contact the service center.
• Do not install the product on the wall by yourself. The product should be installed by a qualified professional specified
by the retail store.
- Installing the product without a qualified professional is dangerous and may cause injury.
CAUTION
Failure to observe these instructions may result in minor injury or damage to the product.
• Ensure that the product is installed a certain distance (at least 100 mm) away from the wall for good ventilation.
- Failure to do so may result in the deformation of the product or a fire due to the increase in the internal
temperature.
• When placing the product on a table or shelf, be careful not to place it on the edge.
- The product may fall, causing personal injury or damage to the product. Make sure to use a table or stand that fits
the product.
• Keep the product away from direct sunlight.
- Failure to do so may result in fire or damage to the product.
• Do not place the monitor close to sources of steam or oil, such as humidifiers and kitchen counters.
- This may result in electric shock or fire.
• Make sure the air vents are not blocked by a tablecloth or curtain.
- Failure to do so may result in the deformation of the product or a fire due to the increase in the internal
temperature.
• Do not install the product in an area with poor ventilation (e.g. on a bookshelf, in a closet, in separate outdoor
structures), and avoid placing on cushions or carpets.
- This could result in fire due to high internal temperature.
• Do not place the product on an unstable or vibrating surface such as a vibrating shelf or tilted surface.
- The product may fall or flip over and cause injury.
• In addition, do not install it in close proximity to hot objects, such as lights.
• If you install the product in a place that does not meet the general conditions, this may cause serious damage to the
product's picture quality, life cycle and appearance. Please check with our service engineer before installing in such a
place.
Places that do not meet the general conditions: places where the product was not meant to be used, such as
•
places where much fine dust or oil mist is generated, places where chemical substances are used, places where the
temperature is too high or low, places where the humidity is too high, or places where the product is likely to be used
for a long period of time (e.g. airports or train stations).