Advertisement
5
Enrollment of remote controls
Up to 4 RC-8x remote controllers can be enrolled. This mode only allows
the controllers to operate the HF-03 hands-free set.
Steps to enroll controllers:
1. Turn the ignition on (power supply assumed).
2. Send the SMS instruction MASTER LEARN RC
3. The GSM pager beeps 3 times (if a siren is connected) and an LED
starts to flash.
Fig. 1: Wiring the alarm in RESET 3 mode.
GSM pager CA-1803BT „Athos"
4. The
simultaneously for approx. 3 seconds (at first, the LED has to flash quickly,
then a single long flash should appear). A siren chirp confirms the enrollment.
By enrolling the first remote control all other remote controls previously enrolled
will be erased (so enroll all the controllers intended for use, one by one).
5. Exit enrollment by turning the ignition off. The GSM pager confirms the
enrollment by sending an SMS message to authorized phones TEL1 to
TEL4.
If no siren has been connected, it is necessary that after finishing the enrollment
you verify that all key fobs are enrolled. Pressing any button on the RC-8x
controller causes a LED of the GSM pager to flash.
Wiring the alarm this way makes it possible to control the car's central locking.
2/6
RC-8x
controller
is
enrolled
by pressing
buttons
MHF56801
and
Advertisement
