Advertisement
Attaching Fixed Tilt Mount to Roll Stand Post
1. Align three (3) mounting holes in Fixed Tilt Mount with corresponding mounting holes in top of Post and fasten Mount
to Post with three (3) #10 x 3/4'' FHMS as shown below. Installation Note: Fixed Tilt Mount must be oriented toward
the intended front of the roll stand as shown below.
#10-32 x 3/4'' FHMS (3)
MP5 Fixed Tilt Mount
Roll Stand Front
2. Remove backing from Lexan Screw Cover and place on top of screw heads as shown below. Procedure is same for
MP2 Mount (shown) or MP5 Mount.
Screw Cover
3. Not shown. Align Basket and Handle with the Fixed Tilt Mount orientation and tighten mounting screws as required to
secure Basket and Handle on the Post.
#10-32 x 3/4'' FHMS (3)
Roll Stand Front
DU-PH-0062-60 Rev A 7/16/07 GCX Corp Page 4 of 7
MP2 Fixed Tilt Mount
Advertisement
