Advertisement
Attaching Utility Basket and Handle to Roll Stand Post
1. Attach two (2) Basket Clips to Utility Basket as shown below left. Insert two (2) #8-32 x 7/8'' PHMS and #8-32 hex nuts
in Basket Clips but do not tighten.
2. Slide Basket Clips over top end of Roll Stand Post (below right) and move Basket to mounting position. Do not tighten
screws at this time. Basket may require re-alignment after the Fixed Tilt Mount is attached.
Basket Clips
3. Position the Handle below the top of the Roll Stand Post opposite the Basket. Fasten Handle to Post with two (2) #10-
32 x 9/16'' PHMS as shown, but do not tighten at this time. Handle may require re-alignment after the Fixed Tilt Mount
is attached.
#10-32 x 9/16'' PHMS (2)
#8-32 x 7/8'' PHMS (2)
#8-32 Hex Nuts (2)
DU-PH-0062-60 Rev A 7/16/07 GCX Corp Page 3 of 7
Advertisement
