Table of Contents
Advertisement
INSTALLATION INSTRUCTION 94
May 1999. Page 3
1.1
Type Numbers
This Installation Instruction covers the following type numbers:
LBB 6030/xx
Mobile with Manual alarm
LBB 6031/xx
Mobile with Manual alarm and location detection
LBB 6032/xx
Mobile with Manual, Not-vertical and No-move alarm
LBB 6033/xx
Mobile with Manual, Not-vertical, No-move alarm and location detection
LBB 6034/xx
Mobile with Manual, Not-vertical, No-move and Tear-out alarm
LBB 6035/xx
Mobile with Manual, Not-vertical, No-move, Tear-out alarm + location detection
/xx indicates the operational frequency of the mobile.
2.
P
OWER SUPPLY
The power to the mobiles is supplied by two LRI sized rechargeable or non-rechargeable batteries (fig. 1 K) or by a
single 3 V (non-rechargeable) lithium type Sanyo CR12600 SE battery. The choice between rechargeable and non-
rechargeable batteries is made by a 3-position switch located inside the mobiles battery compartment (fig. 1L). See
also section 2.2.
WARNING: Never charge non-rechargeable batteries. Always place the programming switch in the mid-
dle position (2) (fig. 1L) for these kind of batteries.
2.1
Recommended battery types
Rechargeable: LBB 5931/02 or batteries with identical specification
Non-rechargeable batteries: Philips Alkaline type LR1 LBB 5312/00 or identical specification
NOTE: When placed in a Philips storage or charging rack type LBB 6150/00, /01, /02 and LBB 6152/00
the mobile receives its power from the charging/storage rack and not from the batteries, however batter-
ies are needed for full operation in a rack.
2.2
Replacing the batteries
1. Opening the battery cover
•
To open the battery cover, slide the battery cover lock (fig.1 F) in the direction of the clip.
•
Use the special tool delivered with the mobile to unscrew the locking screw (fig. 1M) located underneath the
battery cover.
•
Slide the battery cover (fig.1G) downwards
•
Remove the battery(s)
2. Battery type selection
•
Remove the battery(s) (fig.1K)
•
Locate the 3-position slide switch at the rear of the battery housing (fig. 1L).
•
Upper Position 1 = Programming/diagnostics mode only
•
Middle Position 2 = Non rechargeable disposable batteries
•
Lower Position 3 = Rechargeable batteries
3. Battery replacement
•
Place the new battery(s) in the correct position (fig.1K) If rechargeable batteries are used ensure the batteries
are charged before using the mobile.
•
Close and lock the battery cover.
NOTE: Never leave dead batteries in the mobile and never leave batteries in the mobile during transpor-
tation.
Sanyo type CR12600 SE (1 per mobile)
DP 6000 DIGITAL PAGING SYSTEM
Advertisement
Table of Contents
