Battery Charging - National Products hummer hx Owner's Manual

CAUTION
Non-rechargeable batteries are not to be recharged.
Make sure the charger connector is matching with
the battery connector.
Charge the Battery
The first charge will take about 12 hours.
1. Open the battery charger port (located on the backside of near by).
2. Insert the battery charger connector into the charger port.
3. Plug the charger into a standard 120V wall outlet. Note: The charger may feel warm during charging.
This is normal and not a cause for concern.
4. After charging is complete (at least 8 -10 hours, but not more than twenty four hours, with the first charge taking
about 12 hours) unplug the charger from the wall outlet and unplug the battery connector from the charger port.
Plug the battery connector into the c harger port.
Plug the charger into a standard wal l outlet.
®
O nly u se t he N PL 1 2 v olt c harger t o c harge y our N PL 1 2 v olt b attery.
Note: if power flow to the wall outlet is controlled by a switch , make sure the switch is "ON".
Before first-time use, charge the battery for at least 12 hours. Never charge the battery longer than 24 hours.
Recharge the battery for at least 8-10 hours after each use of your vehicle.
Do not charge the battery longer than 24 hours.
Do not charge or store battery upside down . Charging produces explosive gases. Charge away from flames,
sparks and lit cigarettes. Charge in a well ventilated area.
The power indicator on the charger allows you to see that there is power from the wall outlet.
On ce the battery is charged, disconnect the battery connector from the charger connector. Unplug the
charger from the wall outlet. The battery is now ready to be installed in your vehicle. Please see the following
Battery Installation Section for detailed instructions on installing your vehicle:
Plug connectors Plug connectors

Battery Charging

Make sure the brand, voltage and frequency of the
charger are in accordance with the wall outlet.
Batteries are to be inserted with the correct polarity.
The supply terminals are not to be short circuited.
Battery
charger
port
®
Battery Replacement
1. Remove the screw on the back of the seats and
lift the seats out.
2. Disconnect the battery connectors.
3. Remove the four screws on the sides of the battery.
4. Carefully lift the battery out of the battery compartment.
6
Charger