Advertisement

INDOOR
SECURECAM
HD
MT4052
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MT4052 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for media-tech MT4052

  • Page 1 INDOOR SECURECAM MT4052 User Manual...
  • Page 2: Table Of Contents

    Index Basic web setting ������������������������������������������������������������������������������������������ 12 WIFI setting ������������������������������������������������������������������������������������������������������ 12 WAN access setting��������������������������������������������������������������������������������������� 12 Notice ������������������������������������������������������������������������������������������������������������ 3 ONVIF setting �������������������������������������������������������������������������������������������������� 13 Transport and Handling �������������������������������������������������������������������������� 3 Alarm setting ��������������������������������������������������������������������������������������������13 Product introduction 4 Motion Detection Setting �������������������������������������������������������������������������� 13 Product summary �������������������������������������������������������������������������������������� 4 Alarm mode setting �������������������������������������������������������������������������������������...
  • Page 3: Notice

    Notice 3� Do not aim the camera directly into the sun or at other intense light sources that could affect the image quality,  Keep away from the places for high-temperature, heat this will also shorten the service life for the image sen- source and direct sunlight;...
  • Page 4: Product Introduction

    Product introduction ■ Manufacturer puts a label of DDNS at the bottom of each IP Camera� When IP Camera is connected to the Product summary internet, this URL can be used to visit the device; Package for typical production Thank you for choosing this high definition SmartP2P IP Camera, the IP Camera combines a high definition digital ■...
  • Page 5: Overview

    Overview Antenna IR LED Lens Photoresistor Reset RJ45 Power...
  • Page 6: View Video By Wired Connection In Lan

    IP camera to router by network cable and connect computer to the same router� MT4052 Router Insert attached CD to computer driver, install “SearchPro” application and run it, you will see interface, please oper- ate as the following steps: 3) Open web browser and enter address as given in “IP ad-...
  • Page 7: Status Bar

    Notice: Need to download ActiveX when first use, click Click “View Video – Mode 1” to access video interface as “download ActiveX (when first use)”, will display prompt, below� click ‘Download Plug-in’ will download and install the” HY- Player” plug-in automatically� 1 Status bar 1) Enable/disable on-line view;...
  • Page 8: Choose Video Stream

    Note! In this window file location path are defined on local View video by WiFi connection in LAN PC computer, in this window you can manually start/stop re- After finishing the wired connection you can connect the cording or make snapshot. For automatic surveillance func- camera by WiFi�...
  • Page 9: View Video In Internet

    Because the camera supports WPS/QSS, so you can set You should connect your internal network to the internet wireless by simple way as below first and configure port forwarding, please refer to your router manual for further details� 1� Please confirm if the router connected to camera sup- ports WPS/QSS (you can check user manual of the router For example: operation step of port forwarding�...
  • Page 10: View Video By Pc Client Software

    Notice: because the routers are different, so the interface and And then run the Safari browser to view the video� setting method of router are also different, how to do the port Note: Please select the G�711 audio code format for audio forwarding for various routers, please refer to the user manual playback in Quicktime plug-in�...
  • Page 11: All Settings

    Audio parameters rtsp://ip:port/12 (View video by second stream) rtsp://ip:port/13 (View video by third stream) The port is RTSP port� All settings Video setting In the setting, you can adjust the video, audio and image setting according to actual environment for getting best effect�...
  • Page 12: Basic Web Setting

    Web setting Basic web setting The cameras support RTSP protocol, if select “on” of “RTSP authority verification”, you need to enter user name and password when invoke video by RTSP protocol� User can also use third party DDNS, such as www�dyndns� com�...
  • Page 13: Onvif Setting

    Notice: Using the third party DDNS, if the http port is not Alarm setting 80, the port number should be adding to the domain name Motion Detection Setting with colon� Example: http://mydomain.dyndns.org:81. ONVIF setting Please click “save” after the settings are done, and motion The camera supports ONVIF protocol, so it can be intercon- detection takes effect�...
  • Page 14: Alarm Mode Setting

    Alarm mode setting After camera detects any change, it will alarm as several mode� Advanced setting User management Alarm time setting The device will trigger the alarm only during the scheduled time period, you can select the scheduled time according to your request�...
  • Page 15: E-Mail Setting

    FTP setting There are 3 levels of user authorization in it�  Administrator: “admin” has the highest authority� It can do any settings� The factory default password: 123456�  Operator: user can only operate the device but can’t do any settings� ...
  • Page 16: System Setting

    System setting Initialize setting Device information Date and time setting Please select the time zone at first and then select a NTP If you click “Confirm” of Backup setting data, the camera server and obtain time from network time server� will create a file, you can store it to your computer, and you can directly call this file to restore the settings�...
  • Page 17: System Log

    System Log Due to continuous development specification and appear- ance of product are subject to change without prior notice. For technical support please visit www.media-tech.eu.

Table of Contents