Product Usage; Maintenance - Hotpoint Ariston CT NTC IW1 Operating Instructions Manual

body and directly filling it with water, using a
common bottle or jug.
A7 Place a glass or large container under the
dispense area and touch the dispense button to
operate the unit, and touch again to stop the ap-
pliance. Allow water to run through the unit until
the reservoir has been emptied.
Do not consume the water until step A8
has been completed.
The first 3-5 litres of water dispensed may
contain some fine, black carbon particles. car-
bon is a natural, organic material made from
coconut shell so don't worry for your safety.
Clear water should be noticed after flushing
through 3 to 5 litres of water (2 to 3 full re-
servoirs).
A8 Repeat steps a2-a7 five times (5x): this will
completely flush the carbon from the new filter.

PRODUCT USAGE

B1 When the appliance is in standby mode the
button will be blue but when it is touched it will turn
green and water will be dispensed.
If the button is not touched within 2 mi-
nutes of being activated then it will au-
tomatically stop the flow of water and turn the
pump off.
B2 Touch to STOP dispensing water. When you
touch the button to stop water being dispensed
the button will change colour from green to blue.
After one minute the product is in a
stand-by mode, it goes in an energy sa-
ving mode as the UV lamp is off; when the pro-
duct is in this condition, there will be a 2 se-
cond delay before the water is dispensed after
the dispense button is touched so to activate
the UV lamp and purify the water.
Your product has been designed and in-
ternationally certified to the highest
standards of water purification, and guarante-
es at all times, to dispense the best water qua-
lity. The self monitoring system will warn you
of any potential risks, by way of 3 possible
alarms.
B3 Once the Filter has is at 11 months after its
first usage, the Filter icon will flash as a reminder,
and continue to flash until the filter has been re-
placed as per B4 below. During this time, your
machine will continue to dispense water, until B4
below has been reached.
B4 After a 12 month period, both the UV Bulb
and Filter must be replaced to ensure optimal wa-
ter purification. Both the UV Icon and Filter Icon
will alarm 20 times and flash alternately. When
this occurs, no water will be dispensed, until the
Filter and UV Bulb have both been replaced and
the machine reset (to do this you will need to fol-
low steps C1 to C17).

MAINTENANCE

This product is a high performance water machi-
ne, keeping it in good working order will provide
the reassurance of truly great drinking water.
The uv bulb and filter must be replaced
every 12 months to ensure that your ap-
pliance is dispensing the highest quality drin-
king water.
For the correct and effective appliance
working, use only hotpoint-ariston
[hotpoint] replacement kit (read service sec-
tion)
Unplug the Appliance from the mains
before replacing the UV lamp or filter.
It's recommended to do next steps on a wa-
shable surface. After this procedure it's re-
commended that you clean the surface with a
home-use disinfecting product.
C1 Remove the water reservoir from the main
body of the appliance.
C2 Remove the two screws that hold the lid in
place using the screwdriver you can find in the
box.
C3 Remove the lid from the unit by slightly
pushing it back and then lifting it up.
C4 Disconnect the UV lamp connector by hol-
ding it and pressing in the clip on the connector
en
eu
hotpoint.
13