Water softener with water purification function (MP02-5E MP02-6E) ● Instruction and installation manual Thank you very much for purchasing Cleansui MP02 series. Read these instructions carefully before use. An installation instruction and warranty are included with this product, and they must be retained for future reference.
To remove the retained water, please let the water flow for about 2 minutes in the cases of MP02-2E and 3E, about 30 It is not recommended that customers attempt disassembly seconds in the cases of MP02-1E, 4E, 5E, 6E before using or repairs themselves. Contact your supplier. everyday.
MP02 series included parts list Please confirm all parts indicated below are included first. Fixing nut ●Stainless steel container 1set Plate (Including a lid for outer tube, outer tube body, Lid for outer tube clamp and rubber seal) Frame plate ●Cartridge 1 Clamp ●Frame plate...
MP02-5E 5,000L MP02-2E 100,000L MP02-1E 60,000L MP02-3E 150,000L MP02-6E 3,000L ※Please use models with hollow fibre membrane to remove bacteria. (MP02-1E, MP02-4E) ※MP02-2E, MP02-3E, MP02-5E, MP02-6E can not remove bacteria. ※Please use MP02-5E, MP02-6E to remove water hardness. ●Specifications Model No.
●Water volume decreased steeply (clogging). ●You experience an unpleasant taste or odour (filtration performance becomes lower). ・Please contact the store where you bought Cleansui, or installation contractor, and request maintenance. ※Refer to P.8 ・The cartridge is a consumable, and therefore a replacement cost will be incurred.
②Set the clamp, and fasten the handle drain water in order to remove the inside air and wash the filtration components (MP02-1E, 4E: 3 minutes MP02-2E, 3E: 5 minutes MP02-5E, firmly. 6E: 1 minute). And keeping this situation, check there is no leakage.
Page 7
"filtered water flow amount" with the dedicated stop valve If there is a leakage, check the setting of the rubber seal for water purifier (softener). and fasten the handle firmly. Appropriate water flow rate MP02-1E About 200 ml/sec MP02-2E About 200 ml/sec MP02-3E...
The main body of the water purifier ●There is a leakage from water purifier (softener) may be damaged. (softener). Please contact the store where you bought Cleansui, or installation contractor, and request maintenance. 7. After-sale Service ■Before asking for a service (maintenance or repair) ■Replacement of cartridge (sold separately)
8. Installation Precautions Please read this instruction manual carefully. Should you fail to do so and as a result cause damage to the unit, we will not take responsibility. Attention Water pressure inspection Installation is to be done by a plumber only. Measure the water pressure before installation.
Page 10
8-1. Plumbing Dedicated stop valve for ●Connect “T” joint with a nut and water main, and water purifier (softener) dedicated stop valve for water purifier (softener). “T” joint with a nut Attention Pressure-resistant blade Water main For maintenance, the length of pressure-resistant blade hose or hose or flexible pipe flexible pipe is should not be too long (less than 1 metre).
Page 11
If there is a leakage from the water purifier (softener), close the stop valve, and contact system and piping. ●The initial drainage time is an estimated with the store where you bought Cleansui, or installation contractor. one until the bubbles disappear. 8-5. Adjustment of Filtered Water Volume ①Open dedicated faucet for water purifier (softener) fully.
Need help?
Do you have a question about the MP02-1E and is the answer not in the manual?
Questions and answers