Troubleshooting - Remington HC8008AU Use & Care Manual

3. Hold the hair clipper in one hand so that the blades are at the top, and the front
of the hair clipper is facing you.
4. Place your thumb of the opposite hand underneath the blades at the front of the unit,
hold the back of the blade set with your fore finger and middle finger and firmly
press upwards with your thumb. The blade set will detach from the hair clipper.
5. Brush the accumulated hair from the hair pocket and blades.
6. Replace the blade set by inserting the notch (on the inside at the bottom of the
blade set) into the groove of the hair pocket and firmly push down with the palm of
your hand until you hear an audible 'click' and the blade set is locked into place.
STORAGE
When not in use, unplug the hair clipper and store it out of reach of children in a safe
dry place. Never wrap the cord around the hair clipper as this will cause the cord to
wear prematurely and break. Handle the cord carefully for long life and avoid jerking,
twisting or straining especially at the plug connections.

TROUBLESHOOTING

The hair clipper does not work when turned on:
Hair clipper must be charged for a full 16 hours, or use hair clipper while plugged into wall.
Hair clipper cutters do not move:
The cutting unit may be dirty and clogged. Clean the unit as directed in Cleaning &
Maintaining section.
Hair clipper does not hold charge:
Fully discharge the battery by running hair clipper until it stops; then follow recharging
instructions (see section on Charging Your Hair Clipper).
This product is not suitable to use in a bath or shower.
This product conforms to radio frequency interference requirements.
Any product purchased and used commercially carries a limited 90 Day Warranty.
8