Start And Stop An Event; Broadcast An Event - VBrick 9000 User Manual

If you'd like to record your presentation, click
recording your presentation.
At any time during the event, you can mute audio and resend the paused image by clicking
the
Broadcasting
button.
When you are finished with your event, click
the recording.
Each control state is summarized below along with

Start and Stop an Event

To start an event:

1. Click the
Start Program
2. To stop the event, click the
When an event has started and Broadcast is off, the following occurs:
• Audio is muted
• Video is replaced with a static pause image.
• Transmitters and Servers will continue to stream the pause image. Connected players and
servers must not close.
• If Record is on, it will be paused. The Archiver will stop writing to the current file. The
file will be left open.

Broadcast an Event

To broadcast an event:

1. Click the
Broadcast
2. To stop broadcasting the event, click the
When an event has started and Broadcast is on, the following occurs:
• Audio and Video play as configured
• You may switch the layout at any time and transition will occur seamlessly without the
need to restart the broadcast so long as the layout has been previously configured
correctly.
• If Record is on, the Archiver will resume recording at the next I frame. Timestamps will
be adjusted so the paused portion will be seamlessly skipped by the player
VBrick 9000 Encoder Presenter Guide
button. You may also stop/restart recording by clicking the
button. It will change to an
End Program
button. It will turn green and display Broadcasting.
. You will be alerted that you are also
Record
to shut down the stream and end
End Program
messages.
Advanced Status
button.
End Program
button.
button.
Broadcasting
Presenter Mode Features
Recording
13