sinmag HS-3 Owner's Manual
  1. Manuals
  2. Brands
  3. sinmag Manuals
  4. Kitchen Appliances
  5. HS-3
  6. Owner's manual

sinmag HS-3 Owner's Manual

Horizontal slicer
Hide thumbs

Advertisement

Table of Contents

OWNER'S MANUAL
HS-3
(Horizontal Slicer)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HS-3 and is the answer not in the manual?

Questions and answers

Андрей
July 16, 2025

Подскажите модели и размеры подшипников механизма

0

Related Manuals for sinmag HS-3

Summary of Contents for sinmag HS-3

  • Page 1 OWNER’S MANUAL HS-3 (Horizontal Slicer)
  • Page 2 CONTENTS Introduction••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••(2) Installation & Commissioning•••••••••••••••••••••••••••••••••••••••••••••••••••(3) Operation•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••(4) Cleaning & Maintenance••••••••••••••••••••••••••••••••••••••••••••••••••••••••••(5) Parts List••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••(6)
  • Page 3 All of the information, illustration and specification contained in this manual are based on the latest product information available at the time of printing. SINMAG reserves the right to make changes at any time without notice. If questions arise during the operation or servicing, please contact us before proceeding.
  • Page 4 INSTALLATION AND COMMISSIONING Installation After uncrating your horizontal slicer, inspect the machine for any damage that might have occurred during shipment. Report any damage to us before proceeding to operate this machine. Never attempt to operate this machine with damaged parts. Select a location for the machine to allow sufficient room for operarion, cleaning and servicing.
  • Page 5 OPERATION Operation Steps 1. Adjust the width of the guide plate outside of the conveyer belt (normally 3 hamburgs’ width is ok), then change the height of the blades according to the desired thickness. 2. Switch on the power supply. 3.
  • Page 6 CLEANING AND MAINTENANCE Clean and Maintenance 1. Please always keep the conveyer belt clean and use the brush and water to clean the conveyer belt. 2. Remember to switch off the electricity after daily use. Please use the soft cloth to clean outside part of the machine and use the brush to clean the inside part.
  • Page 7 PART LIST...
  • Page 8 PART LIST PART NUMBER PART CODE PART NAME HS3001 13HS-03-01 Knife Base Units(Left)1 HS3002 13HS-02 Knife Frame(Left) HS3003 13HS-01 Knife Frame(Right) HS3004 13HS-04-01 Knife Base Units(Right)1 HS3005 13HS-03-02 Knife Base Units(Left)2 15SSD2280*380*2 HS3006 Conveyor Belt HS3007 14HS-19-00 Roller Wheel 2 HS3008 14HS-18-00 Roller Wheel 1...

Table of Contents