System Requirements - ParkerVision USB1500 User Manual

This chapter will guide you through the installation of the ParkerVision Wireless

3.1 System Requirements

• Operational USB Port
• Windows 2000/XP Operating System.
• 500 Kbytes free hard disk space (minimum) for driver and utility program installation.
• 128 MB RAM
• USB Cable
3.2 Installing the ParkerVision USB Wireless LAN Adapter
Note: If you installed your adapter at the end of the last chapter, you can proceed to the next
page of this manual.
Follow the procedure shown next to install the ParkerVision Wireless USB LAN Adapter.
Refer to the appendix for important safety instructions.
Step 1. Locate available USB port on your notebook or desktop computer.
Step 2. Connect the USB cable to the ParkerVision USB Wireless LAN adapter.
Connect the other end of the cable to an open USB port on your computer.
Never force, bend or twist the USB plug into the USB port on either the
USB1500
Chapter 3 :
Hardware Installation
LAN Adapter into your computer
computer or the USB wireless LAN adapter computer or the USB wireless LAN adapter
Insert the USB cable's plug into the socket on the rear
of the HZ1500USB Adapter, then insert the other end
into an available USB port on your computer.
Wireless PC LAN Adapter
15 15