Precautions - HAKO 701 Instruction Manual

Precautions

Warnings, cautions and notes are placed at critical points in this manual to direct the operator's
attention to significant items. They are defined as follows:
WARNING: Failure to comply with a WARNING may result in serious injury or death.
CAUTION : Failure to comply with a CAUTION may result in injury to the operator,
or damage to the items involved.
Remove the pump securing screw (M4 × 25 marked red) from the bottom of the station.
Failure to do so may result in serious problems.
When the power is on, the tip and the nozzle temperature is between 200℃/392℉ and
480℃/896℉. Since mishandling may lead to burns or fire, be sure to comply with the
following precautions.
● Do not touch the metallic parts near the tip and the nozzle, nearby plastic parts
and the spring iron holder.
● Do not use the product near flammable items.
● Advise other people in the work area that the unit can reach a very high tem-
perature and should be considered potentially dangerous.
● Turn the power off while taking breaks and when finished using the unit.
● Before replacing parts or storing the unit, turn the power off and allow the unit
to cool to room temperature.
● This appliance can be used by children aged from 8 years and above and
persons with reduced physical, sensory or mental capabilities or lack of experi-
ence and knowledge if they have been given supervision or instruction con-
cerning use of the appliance in safe way and understand the hazards involved.
● Children shall not play with the appliance.
● Cleaning and user maintenance shall not be made by children without supervision.
● The unit is for a counter or workbench use only.
To prevent damage to the unit and ensure a safe working environment, be sure to comply
with the following precautions.
Do not use the unit for applications other than soldering or desoldering.
●
Do not rap the desoldering gun against the work bench to shake off residual solder, or otherwise
●
subject the iron or the gun to severe shocks.
Do not modify the unit.
●
Use only genuine HAKKO replacement parts.
●
Do not wet the unit or use the unit when your hands are wet.
●
Set the ceramic paper filter (S) for the filter retainer (station), and the ceramic paper filter (L) for
●
the filter pipe (gun).
Maintain the soldering iron or the desoldering gun and the station.
●
While using the unit, don't do anything which may cause bodily harm or physical damage.
●
WARNING
CAUTION
2