Advertisement
DESCRIPTION OF FUNCTIONS
1. [POWER]
Press this switch to switch on or off
2. [FUNC]
Press this switch to select between the functions "Cooling", „Heating" or „"Dehumidity"
3. [TEMP+]
Press this switch in the cooling function in order to set the required room temperature by 1°C respectively up to a
maximum temperature of 30°C.
Press this switch in the heating function in order to set the required room temperature by 1°C respectively up to a
maximum temperature of 25°C
4. [TEMP-]
Press this switch in the cooling function in order to set the required room temperature by 1°C respectively up to a
minimum temperature of 17°C.
Press this switch in the heating function in order to set the required room temperature by 1°C respectively up to a
minimum temperature of 15°C
5. LED-DISPLAY
The display shows the default temperature in operation.
By pressing the [TEMP+] or. [TEMP-] switch, the required target temperature is briefly displayed. On pressing
the [TIMER] switch, the number of hours is briefly shown until activation or deactivation. After each manual
setting, the display automatically shows the default temperature. In the dehumidification function, „dH" is shown
in the display. Error messages are also shown in the display.
6. [SPEED]
Press this switch to set the ventilation speed to„LOW", „MID" (middle), „HI" (high) or „AUTO" (automatic). If
„AUTO" is selected, the ventilator operates at temperature differences larger than 9 degrees at top speed. If the
temperature reduces to a difference smaller than 4 degrees, the ventilator switches to middle blower position. If
the temperature reduces further until the target temperature, the ventilator switches to the lowest blower position.
7. [TIMER]
Programmable time switch with start and residual time
Starting time: This function is used to switch on the unit automatically when the time entered has expired.
Proceed as follows:
i) Press [TIMER] switch in Stand-by (the unit is connected but not in operation), to enter the required number of
hours after which the unit is to start.
ii) Select the required function (cooling, heating, dehumidification) and set the required temperature.
iii) When the set number of hours has expired, the unit starts automatically.
If you press the [POWER] switch before the time has expired, the time programming is deleted, the
TRANSFORM unit switches on and can be operated in the required operating mode.
Residual time: This function is used to automatically deactivate the unit when the time entered has expired.
Proceed as follows:
i) Press the [TIMER] switch during operation and enter the required number of hours after which the unit is to
switch off.
ii) After the flashing of the number of hours on the LED has stopped, you can select the required function
(cooling, heating, dehumidification) and the required temperature.
iii) When the set number of hours has expired, the unit switches on automatically.
If you press the [POWER] switch before the time has expired, the Timer programming is deleted and the
TRANSFORM unit switches off.
Advertisement
