Download Print this page

Installation And Start-Up Procedures - Fleck 3200ET Service Manual

Remote meter

Hide thumbs Also See for 3200ET:

3200ET Remote Meter

Installation and Start-Up Procedures

Record Remote Meter Programming Here:

Water Hardness

System Capacity

Regeneration Time

Regeneration Signal Time ___________________________________________

Notes:

______________________________________________________________________________

1. Follow the installation procedures contained within the remote meter service manual.

2. The remote meter/timer should be installed with the inlet and outlet and connections (if any) made in accordance

with the manufacturer's recommendations and to meet all applicable plumbing codes.

3. Follow the installation and start-up procedures contained within each valve(s) service manual.

4. Referencing the wiring diagram furnished with each valve in the system, make the proper electrical connections to

the remote timer. All electrical connections must be made in accordance with the manufacturer's recommendations

and to meet all applicable electrical codes.

5. During cold weather it is recommended that the installer warm the remote timer up to room temperature before

energizing.

6. Plug the remote timer into an approved power source. The valve(s) connected to the remote timer may then cycle

themselves back to Service.

Page 2

___________________________________________

Printed in U.S.A.

Table of Contents