INSTALLATION INSTRUCTION # 44-0044A INSTALLATION INSTRUCTIONS 50-0305x-015 SERIES 1181272 1999 DODGE DURANGO * 2. Powered screwdriver or drill with adapter 4. Razor knife or similar 6. 1/4" Hex Socket Bit 8. Audiovox Series 640/650 Video Module Nov. 8, 1999 Printed in the U.S.A...
Page 2
MATERIALS PROVIDED FOR INSTALLATION: ITEM Description SCREW, # 10 X 1/2" HWH SCREW, 6-32 X 3/4" PPH WASHER, 3.5 mm SCREW, # 8 X 1 1/2" PWH SCREW, # 6 X 1/2" PFH MOUNTING BRACKET SPEAKER GRILLE CONSOLE COVER PLATE COVER PLATE DECAL INSTALLATION INSTRUCTION # 44-0044A Nov.
Page 3
I. PREPARATION OF VEHICLE INTERIOR FIGURE 1 2. Using the front edge of dome light opening as a reference location, carefully measure & trim headliner as shown. Caution: Before cutting headliner material, check for wiring or other componentry above headliner. Cut only where indicated.
Page 4
6. Make sure tabs on mounting bracket engage O.E. roof brace and notch aligns with center line. See Figure 4. FIGURE 5 FIGURE 4 7. Construct a jumper harness that will connect the vehicle’s dome light wires to the lights in video system.
Page 5
10. Install and route all video and audio cables, and any other added component requirements to their respective places in the vehicle. Refer to component installation instructions for wiring diagrams. The suggested routing of the video system cable is as follows: Above the headliner from video system to B-pillar.
Page 6
13. Release video screen from locked position. Lower video screen to viewing position for access to mounting location in top of video system housing. 14. Raise video system into approximate position and connect all wiring to components. Connect wiring and cabling to video system per instruction included with video system.