Table of Contents
Advertisement
Pass Thread Through
Hole in Bobbin
5. Place spool of thread on spool pin
over the spool pin felt and lead
thread through top cover and
tension-assembly thread guides
and around tension disc .
OFF
ON
6. Pass thread, from the inside,
Bobbin Winder Switch
through hole in bobbin .
7. Move bobbin winder switch to
ON position, hold thread end as
shown, and start the machine.
8. Cut off thread end after a few
coils have been wound on the
bobbin .
9. When required amount of thread
has been wound (winding will
stop when bobbin is full), move
bobbin winder switch to OFF
position, and cut thread .
10 . Tighten stop-motion screw by
turning it away from you with
right hand, while holding the
hand wheel with your left hand .
9
Hide quick links:
Advertisement
Table of Contents
