RotoZip RZ5 Operating And Safety Instructions Manual page 15

RZ 2610954840 07-07
locks to engage square end of drive bit into
attachment.
5. Position attachment as shown and lock the
lock lever.
Use the allen wrench to adjust the lock lever
adjustment screw.
COLLAR
LOCK LEVER
ADJUSTMENT SCREW
REMOVING AND INSTALLING
ABRASIVE CUT OFF ATTACHMENT
(Standard models)
1. Depress and hold the shaft-lock in and
rotate the collet nut and shaft until the shaft-
lock engages and holds the shaft.
2. Insert the 1/4" collet into the collet nut.
Loosely thread the collet nut onto the output
shaft (Fig. 3).
3. Insert drive bit into the collet until it stops,
and securely tighten the collet nut with the
wrench.
4. Open locking lever and position attachment
onto the collar. Note: It may be necessary to
COLLAR
OUTPUT
SHAFT
8/16/07 3:55 PM
KEYLESS CHUCK
WHEEL GUARD
LOCK LEVER
DRIVE BIT
LOCK LEVER
COLLET
COLLET NUT
DRIVE BIT
LOCK LEVER
ADJUSTMENT
SCREW
LOCK LEVER
Page 15
Overtightening the lock lever
!
adjustment
CAUTION
permanently damage the locking mechanism.
Test the tightness of the lever after each full
turn of the adjustment screw.
FIG. 2
rotate attachment slightly and hold both the
tool and attachment shaft locks to engage
square end of drive bit into attachment.
5. Position attachment as shown and lock the
lock lever.
Use the allen wrench to adjust the lock lever
adjustment screw.
Overtightening the lock lever
!
adjustment
CAUTION
permanently damage the locking mechanism.
Test the tightness of the lever after each full
turn of the adjustment screw.
FIG. 3
WHEEL GUARD
LOCK LEVER
-15-
screw can
GUARD
LOCK LEVER
ADJUSTMENT
SCREW
SHAFT LOCK
screw can
GUARD LOCK LEVER
ADJUSTMENT
SCREW
SHAFT
LOCK