Table of Contents
Advertisement
en | 4 2 | User guide | CP9680 AutoScanner® Plus
Special Tests
O2 Monitor Tests
Diagnostic Monitor Tests
On-Board Systems
Vehicle Information
Oil Light Reset
Charging System Monitor
Modules Present
Component Locator
Acronyms
The types of protocols (communication types) sup-
ported by the scan tool are:
•
ISO 9141-2 protocol is shown as ISO.
Modules Present
ID Protocol
$40 ISO*
Press ENTER to continue
•
SAE J1850 protocol is shown as VPWM or PWM.
Modules Present
ID Protocol
$10 VPWM*
Press ENTER to continue
Modules Present
ID Protocol
$10 PWM*
Press ENTER to continue
•
ISO 15765-4 protocol is shown as CAN.
573102 | REV. A | 07.2015
OR
Modules Present
ID Protocol
$01 CAN*7e9
$00 CAN*7e8
Press ENTER to continue
Since CAN vehicles use module IDs larger than 2 digits,
the Scan Tool assigns a 2 digit module ID to be used in
place of the actual CAN module ID. The module ID
assigned for the CAN module ID is used in all functions
of the Scan Tool.
•
ISO 14230-4 protocol is shown as K2K (Keyword
2000).
Modules Present
ID Protocol
$10 K2K*
Press ENTER to continue
In the above examples, the * indicates the protocol used
to communicate to the vehicle's control module.
6
Troubleshooting
6.1
Error Messages
Check the following if an error message displays:
•
Verify ignition key is in the ON and not in the ACCES-
SORIES position.
•
Make sure the DLC Cable is attached to vehicle's
data link connector (DLC) and scan tool.
•
Look at DLC and check for cracked or recessed pins,
or for any substance that could prevent a good
electrical connection.
•
Test for continuity between the DLC wiring and the
computer. In an extreme case, there may be a bro-
ken wire.
•
Check for bent or broken pins.
•
With the engine off, check for blown fuses in the
vehicle fuse box.
•
Make sure the vehicle's control module has a good
ground. If the computer case is grounded, then
clean the connection and apply a conductive (dielec-
tric) grease to the mating surfaces.
•
With the key on engine off (KOEO), verify vehicle
battery voltage is at least 8.0V.
Bosch Automotive Service Solutions Inc.
Advertisement
Table of Contents
