Advertisement
Turbocharger & Piping Installation
1. Remove entire exhaust system up to the exhaust manifold (Retain nuts and gaskets for future
use). Remove intake hose from the intake manifold and twist out of way for now. Remove PCV
hose from intake manifold to valve cover. See Fig. 1
2. Remove oil pressure sending unit from block. Install oil feed line fitting into tee. Install supplied
brass tee into the oil pressure sending unit hole in the block. Install pressure sending unit into
brass tee. Install oil feed line onto oil feed fitting in brass tee and set aside for now. See Fig. 2
*Note: Use thread sealer on oil feed tee & fitting
Advertisement
