Belling BDW60IC Instruction Manual page 14

R emarks:
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
The entire filter assembly should be cle aned once a week .
C leaning t he Filter
To clean the coarse filter and the fine filter, use a cleanin g brush. Reassemble the filter parts as shown in the figures
on the last page and reinsert the entire assembly in the dish washer, positioning it in its seat and pressing downwards.
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dish wash er.
C leaning The Door
Protect Ag ainst Fre ezing
please take frost protection measures on the dishwasher in winter. Every
please operate as follows
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to gather the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
If your dishwa sher cann ot wo rk becaus e o f the ice,
p lea se co ntac t p rofessio na l s ervic e p ersons .
C leaning t he Spray Arms
It is necessary to clean the sp ray arms regularly for hard
water chemicals will clo g the spray arm jets and bearings.
To remove the upper spray arm, hold the nut, rotate the arm
clockwise to remove it.
To remove the lower spray arm, pull out the spray arm upward.
Wash the arms in soapy and warm water and use a soft brush to
clean the jets. Replace them after rinsing them thoroughly.
When cleaning the filt ers, don't knock on them. Otherw ise, the filters could be
contorted and the performanc e of the d ishwash er could be decreased.
To clean the edge around the door, you sh ould use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
：
time a fter wash ing cycle s,