Ch Ange The Programme; At The Ene Of The Wash Cycle - Belling BDW60IC Instruction Manual

Premise:
1 A cycle that is underway can only be modifie d if it has o nly been running for a short time. Otherwise, the
deter gent may have already been released, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refille d (see the section entitled " Loading the
Detergent " ).
2 Open the door ,press the Program button
then you ca n ch ange the program to the desired cycle settin g (see the section entitled " Starting a
wash cycle. . ." ).
If you open the door
stop blinking and the buzzer will mooing every minute unless you close the door . After
you close the door ,the machine will k eep on w orking after 10 seconds.
A forgotten dish can be added any time before the detergent cup opens.
1
Open the door a little .
2 After the spray arms stop working, you can open the door
completely.
3
Add forgotten dishes.
When the working cycle has finished, the buzzer of the dishwasher will sound for 8 seconds, then stop. Turn off
the appliance using the ON/OFF button, shut off the water supply and open the door of the dishwasher.
Wait for a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they
are still hot and more susce ptible to breakage. They will also dry better.
Switc h Off t he Dis hwasher
The program light is on but is not blinking, only in this case the programme has ended.
1.Switch off the dish washer by pressing the ON/OFF button.
2.Turn off the water tap!
Open the door car efully.
Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around 15 minutes
before removing from the appliance.
Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In this way they
will be cooler and the drying will be improved.
Unloading t he dis hwash er
It is normal that the dishwasher is wet inside.
Empty the lower baske t first and then the upper one. This will avoid water dripping from the upper Basket onto
the dishes in the lower one.
Wash the arms in soapy and warm water and use a soft brush to
When following this procedure from step1 to step 3, the filter system will be removed;
clean the jets. Replace them after rinsing them thoroughly.
when following it from Step 3 to Step 1, the filter system will be installed.
more than 3 seconds
during a wash cy cle
It is dangerous to open the door when washing, because the hot water may scald you.
, the mach ine will be in standby state,
, the m achine will pause. The program light will
4
Close the door
5 The dishwasher will run after 10 seconds.