Checking The Time Clock; Setting The Start, Stop And Logging Duration; Duration Of Trip, At Least; Interval Between Each Reading - Escort iMiniPlus PDF User Manual

Display Units of measurement
You can select the LCD to display the temperature in Celsius or Fahrenheit.
Display change rate
You can select a frequency or 1, 2, 3 or 4 seconds that the LCD scrolls between the Highest, Lowest, Average and
out-of-spec information. Note that the "LATEST" reading will only change at a frequency equal to the logging
interval. So if the iMiniPlus is programmed to log every 1 minute that will be the rate at which the "LATEST"
reading changes.
9.4

Checking the time clock

There may be times when the time clock on the iMiniPlus
PDF Logger may alter. This is the case when the battery is
removed and not replaced within 30seconds.
If you have removed batteries from the iMiniPlus PDF
Logger for any length of time, make sure you either select:
 Change to the date and time on this computer
(default)
 Set to
The software will always default to the "Change to the
date and time on this computer." option.
9.5

Setting the Start, Stop and logging duration

9.5.2

Interval between each reading

This is sometimes called the logging interval or logging rate and is described as the period of time between each
logged reading. If the interval is a low number, then the iMiniPlus memory will be filled quickly compared to a high
number. If you want to record acute changes in temperature over short periods of time, it is best to select a low
number or faster logging interval. If you want a logger to record readings over a long period of time, then you will
be best advised to use a lower logging interval or high number.
The fastest logging interval the iMiniPlus PDF Logger can log at is every 5 seconds.
The slowest logging interval the iMiniPlus PDF Logger can log is every 18 hours.
iMiniPlus PDF Logger User Guide v2.0
9.5.1

Duration of trip, at least

If you are using the iMiniPlus PDF Logger to record the
temperature of a trip (shipment) for instance, you have the
option of setting up the parameters yourself or let the Console
Pro software calculate these automatically for you.
The software takes the total memory available (8048 readings)
and calculates the maximum interval between each reading
and the finish log trip time and date based on the trip duration
you select. You can select 1 day to 60day trip duration this way.
You will notice that each time you select trip duration, the
logging interval will change.
- 19 -
Date/Time Tab -
Check that the date
and time is correct.
Startup Tab - Configure the start,
recording and stop conditions.