Cable Diagrams - Mitsubishi FR-A700 Manual

5

Cable Diagrams

The cable diagrams shown below may be different from cable diagrams recommended by Mitsubishi Electric
Corporation. Please be assured there is no operational problem in applying the cable diagrams shown in this
manual.
• The FG pin of the External Device body must be D-class grounded. Please refer to the manual of the External
Device for more details.
• SG and FG are connected inside the Display. When connecting SG to the External Device, design the system
not to form short-circuit loop.
• Connect the isolation unit if noise and interference affect communication.
Cable Diagram 1
Display
(Connection Port)
*1
GP3000 (COM1)
AGP-3302B (COM2)
GP-4*01TM (COM1)
*2
ST (COM2)
LT3000 (COM1)
*3
IPC
*4
GP3000 (COM2)
GP-4106 (COM1)
*5
GP4000 (COM2)
GP-4201T (COM1)
SP5000 (COM1/2)
*1 All GP3000 models except AGP-3302B
*2 All ST models except AST-3211A and AST-3302B
*3 Only the COM port which can communicate by RS-422/485 (4 wire) can be used.
" IPC COM Port" (page 7)
*4 All GP3000 models except GP-3200 series and AGP-3302B.
*5 All GP4000 models except GP-4100 Series, GP-4*01TM, GP-4201T and GP-4*03T
GP-Pro EX Device/PLC Connection Manual
COM port conversion adapter by Pro-face
CA3-ADPCOM-01
1A Terminal block conversion adapter by Pro-face
1B
Online adapter by Pro-face
1C Terminal block conversion adapter by Pro-face
Online adapter by Pro-face
1D
1E
RS-422 Terminal Block Conversion Adapter by Pro-face
PFXZCBADTM1
1F
1B
Cable
+
CA3-ADPTRM-01
+
User-created cable
User-created cable
CA4-ADPONL-01
+
CA3-ADPTRM-01
+
User-created cable
CA4-ADPONL-01
+
User-created cable
User-created cable
*6
+
User-created cable
User-created cable
62
FREQROL Inverter Driver
Notes
Cable length: 500m or
less
Cable length: 500m or
less
Cable length: 500m or
less
Cable length: 500m or
less