Introduction - Aztec EB 897 01 Installation Instructions Manual

1. INTRODUCTION

The Aztec Electric Boiler is a wall mounted electric
central heating boiler designed with smaller properties in
mind. Fitted vertically only and requiring access to the
front and the right hand side of the boiler for servicing.
Once the boiler is switched on it is fully controlled by an
automatic management system which monitors the safety
and running functions of the boiler. Designed to work on
a fully pumped wet system only. The boiler produces hot
water by passing water over electric heating elements
housed in an insulated copper heat exchanger.
There are five boilers in the range with outputs ranging
from 2 kW (6825 Btu/hr) to 12 kW (41.000 Btu/hr).
The Trianco Aztec Wall Mounted Boiler has been designed to conform to European
EN60335-1:1994/A16:2001, EN60335-2-35:1998/A1:2000,
EN55014-1:2000, EN55014-2:1997, EN61000-3-2:2000 and EN61000-3-3:1995.
THE PERSON(S) WHO INSTALLS THIS APPLIANCE, SERVICES OR CARRIES OUT
ANY REMEDIAL WORK, I.E. ELECTRICAL FAULT FINDING, MUST
HAVE SUITABLE ENGINEERING QUALIFICATIONS.
WARNING: DO NOT SWITCH ON THIS APPLIANCE IF THERE IS ANY POSSIBILITY
THAT THE WATER HEAT EXCHANGER IS FROZEN.
THE INSTALLATION OF THIS APPLIANCE MUST MEET THE REQUIREMENTS OF THE
CURRENT ISSUE FOR ELECTRICAL INSTALLATIONS IEE WIRING
Supplied By www.heating spares.co Tel. 0161 620 6677
Directive/Standards.
REGULATIONS (SIXTEENTH EDITION)
2
IMPORTANT SAFETY NOTES
Read these instructions before installing your boiler.
The heating system must comply with the latest editions
of British Standards 5449 and The Building Regulations,
and Electrical Wiring Regulations BS 7671.
1. Always switch OFF the electrical supply before removing
the cover.
2. If any part of the boiler is modified, then the guarantee
/warranty will be invalidated.
We recommend that you keep these instructions in a
place near your appliance for easy reference.