Bosch GSA 18 V-LI Original Operating Instructions page 9

OBJ_BUCH-776-001.book Page 9 Thursday, June 5, 2008 1:27 PM
Product Features
The numbering of the product features refers to
the illustration of the power tool on the graphics
page.
1 Saw blade*
2 Adjustable footplate
3 Saw blade holder
4 Locking sleeve for saw blade
5 Stroke rod
6 Stroke speed selector switch
7 On/Off switch
8 Battery release button
9 Battery*
*The accessories illustrated or described are not in-
cluded as standard delivery.
Technical Data
Reciprocating Saw
Article number
Rated voltage
Stroke rate at no load n
0
– 1st gear
– 2nd gear
Tool holder
Stroke rate control
Stroke
Cutting capacity, max.
– in wood
– in non-alloy steel
– Pipe diameter
Weight according to EP-
TA-Procedure 01/2003
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
Bosch Power Tools
Assembly
Battery Charging
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
The lithium ion battery is protected against deep
discharging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
GSA 18 V-LI
Professional
3 601 F4J 0..
chine has been automatically switched off. The
V= 18
battery can be damaged.
The battery is equipped with an NTC tempera-
0 – 2400
spm
ture control which allows charging only within a
spm 0 – 2700
temperature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
SDS
ner.
Observe the notes for disposal.
mm 28
Removing the Battery
mm 250
The battery 9 is equipped with two locking levels
mm 20
that should prevent the battery from falling out
mm 130
when pushing the battery unlocking button 8 un-
intentionally. As long as the battery is inserted in
the power tool, it is held in position by means of
kg 3.4
a spring.
To remove the battery 9, press the battery un-
locking button 8 and pull the battery out of the
power tool toward the rear. Do not exert any
force.
Do not continue to press the
WARNING
On/Off switch after the ma-
2 609 932 632 | (5.6.08)
English | 9