User Notes; Software Installation; Hardware Installation - Gigastone SI-100 User Manual

Gigastone
Smart Imaging
SI-100 Digital Microscope User Manual

2 User Notes

1. Do not use or store the microscope in extremely high or low temperature or humid place.
2. Do not drop, knock, or shake this device.
3. Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the
microscope.
4. Do not look directly into the LED light source. This may cause eye discomfort.
5. Do not leave it to kids under 5 years old.
6. The measurement function can only provide rough values. Gigastone is not responsible
for its results.

3 Software Installation

Important notice: DO NOT connect the USB cable of the SI-100 to the PC before installing the
software. Otherwise, it may interfere installation process.
1. Use the CD delivered with your SI-100 to install software and drivers.
Execute "Setup.exe" and the Installshield wizard will start. (A "User Access Control" dialog
2.
may appear on some systems. Select "Continue" or "Yes").
Click "Next" and "Install". Install process will complete in a few minutes.
3.
Click "Finish" to close the setup dialog when installation is complete.
4.
5. Complete manual can be found in the SI-100 CD.

4 Hardware Installation

1. After install the SI-100 software and drivers, connect SI-100 to the USB port of your
computer.
2. Please use USB 3.0 port if your computer has it to achieve best performance. SI-100 only
supports VGA and 720p on USB 2.0 due to limited bandwidth.
3. The driver will be installed automatically at the first-time use. Please be patient and wait
for the notification of installation success.
4. Start SI-100 Software by double clicking the shortcut on the Desktop or Start Menu.
4 Rev.A