Folder Management - Gigastone SI-100 User Manual

Gigastone
Smart Imaging
SI-100 Digital Microscope User Manual

12 Folder Management

Folder manager set the default folder to store the image and video. Click
folders.
12.1 Select Default Image Folder
Select the folder and click "OK" to apply this setting. New image and video will be stored in
the selected folder.
12.2 Import or Create Folder
Click
12.3 Remove folder
Right click on the folder and select "Exclude folder".
13 Calibration
SI-100 is calibrated in the factory before shipping. User is not necessary to do calibration. The
calibration function is provided for trouble-shooting only.
13.1 User Calibration Process
1. Use
2. Place the calibration pattern sheet under the microscope for previewing.
3. Adjust the roller until the calibration pattern is very clear and sharp.
Press "Freeze" to freeze the video. That will make the following steps easier.
4.
5. Enter the measured length of the pattern in the previewing window.
6. Enter the magnification on SI-100 roller.
Adjust two control points to the calibration pattern's edge.
7.
8. Click Apply to finish the calibration.
to create or import folder into SI-100 software for further use.
at measurement tools to open the calibration dialog.
13
to control
Rev.A