Section 3 - Fitting And Adjusting The Dynamic Footrests - Active Design Dynamic Footrest Operating Instructions Manual

SECTION 3 – FITTING AND ADJUSTING THE DYNAMIC FOOTRESTS
This section applies to Active Dynamic Footrest Assembly (new type) only. The Dynamic Footrest
Assembly (Double Plate Type) is adjusted in the same way as a standard CAPS II Footplate.
Adjusting the Height of the Dynamic Footrest Assembly
1. To adjust the height of the footrest,
loosen the grub screw. Loosen the two
retaining bolts until you can slide the
footrest assembly up and down the
footrest drop tube. When you have
reached the required position, tighten
the retaining bolts.
2. You may want to use a spirit level to
ensure the footplate is level.To adjust
the level, loosen the two retaining bolts
above and rotate the footrest assembly
around the drop tube. Alternatively,
adjust the footplate as shown in X
below.
6