mini-box DCDC-USB-200 Quick Installation Manual

6-34v high power, intelligent dc-dc converter with usb interface

DCDC-USB-200

6-34V high power, Intelligent DC-DC converter with USB interface

Quick Installation Guide

Version 1.0c

P/N DCDC-USB-200

Introduction

The DCDC-USB-200 is a powerful DC-DC power supply designed to power a

wide variety of devices. This DC-DC has a range of intelligent functions not found

in any tradition USB converters. Features include USB interface, programmable

output voltage and scripting as well as automotive modes.

The DCDC-USB-200 device is able to send ON/OFF 'pulse signals' to

motherboards based on voltage levels or Ignition sensing, making it an ideal

device for automotive or battery powered installations.

This unit has a wide input range (6-34V) and it can provide a tightly regulated

output ranging from 6 to 24V (default set to 12V). Emissions are reduced using 2

out of sync, spread spectrum buck-boost converters.

Table of Contents

Do you have a question about the DCDC-USB-200 and is the answer not in the manual?

Page 1 Version 1.0c P/N DCDC-USB-200 Introduction The DCDC-USB-200 is a powerful DC-DC power supply designed to power a wide variety of devices. This DC-DC has a range of intelligent functions not found in any tradition USB converters. Features include USB interface, programmable output voltage and scripting as well as automotive modes.
Page 2 ATX DC-DC Converter Series Quick installation Instructions VOUT DCD-USB-200 Fig 1.0, DCDC-USB-200 layout J7: Configuration jumpers for Voltage, Mode and Timings. Left mini-FIT connector: Power input, V(in) – (Red), GND, Ignition *(Yellow) Right mini-FIT connector: Power output V(out), GND.
Page 3 2, 3 and 4, see table 1. After making a jumper change, the DCDC-USB-200 unit needs to be power cycled in order for the new setting to take effect. NOTE: Finer voltage adjustments are available via USB settings, see Advanced USB Configuration manual.
Page 4 11.2V, power will be cut off in order to prevent battery drainage. Default timing schemes HardOFF OffDelay Never 1min 1min 15 min 1min 15 min Never 30 min 1 min 2 hour Never DCDC-USB-200 Quick Installation Guide Page 4...
Page 5 Efficiency, MTBF: MTBF >100K hours at PSU(temp) < 65 Celsius. NOTE: All solid polymer capacitor design, rated >50K hours at 85C or 500K hours at 65C. Shipping and storage: Temperature -40 to +85 degree centigrade. Relative humidity 5 to 95 percent, non-condensing. DCDC-USB-200 Quick Installation Guide Page 5...