Table of Contents
Advertisement
3. MJPEG add timestamp on record: Select this to enable the function.
4. MJPEG compressed into MPEG-4 format: Select this to enable the function, this will
use less space for recorded files.
5. Automatically recovered once recording space is full: If selected, once the hard
disk is full, it will recover automatically.
2.3.1.2 Capture:
1. Add/Delete: Click this to set/delete the path for snapshot files to be saved.
2. Open the folder when capture image: if selected, this will pop-up the folder when
capture image is saved.
2.3.1.3 Alarm:
1. Alarm Record: Select this to activate record function once alarmed.
2. Alarm recording time: Set the duration for every alarm, this can be
30/60/120/180/300 seconds.
3. MJPEG add timestamp on record: Select this to enable the function.
4. Alarm pop-up E-map: Select this to enable the function, this will pop-up the E-map
which was set once alarmed.
2.3.1.4 Auto run
1. Program runs automatically connect all the devices: If selected, when running the
program, this will connect all the devices which were set successfully automatically.
2. Auto run when computer powering on: If selected, when your computer starts up
the software will run automatically. You can save the username and password here in
advance.
8
Advertisement
Table of Contents
