Cleaning, Care And Maintenance - Buffalo GF256 Instruction Manual

START/STOP: Press START/STOP to start timer, press again to stop. The timer will
provide an audible alarm after the set time. The alarm will beep 10 times and the display will
continue to flash until timer is reset (press the START/STOP button)
UP: Press UP to add extra time
DOWN: Press DOWN to reduce time
PROGRAM: There are a total of 6 programmable timer settings. The default factory
program settings are given below.
To change the length of a program select the program you want to change by scrolling using
the PROGRAM button. Adjust the program time by using the UP and DOWN buttons. Press
START/STOP to commence the count down. The new program time will be automatically
stored.
NOTE:
If the unit is left without power for more than 24hrs the timer settings
will revert to the factory defaults.

Cleaning, Care and Maintenance

If grease is permitted to accumulate, it will begin to carbonise into a hard substance that is
extremely difficult to remove. To prevent this follow the cleaning steps below:
•
Always turn Off the appliance and disconnect from the power supply before
cleaning.
• Allow the appliance to cool before cleaning but for best results clean the plates
when they are still slightly warm.
• Use warm, soapy water and a damp cloth to clean the exterior of the appliance.
• Take care when using scrapers to remove cooking residues as they can damage the
cooking surface.
• Dry thoroughly after cleaning.
• A BUFFALO dealer or qualified technician should carry out repairs if required.
NOTE: IT IS VITAL THAT THE COOKING SURFACE IS RE-SEASONED
AFTER SCOURING.
WARNING: DO NOT USE STEEL WOOL AS IT MAY LEAVE SHARDS THAT
COULD CONTAMINATE FOOD.