HP ProLiant DL360 G7 Maintenance And Troubleshooting Manual page 19

No.
• DL360G7 SRVR
DUAL PORT 1GB
NIC
• DL360G7 SRVR
FAN FRU
• DL360G7 SRVR
2GB MEMORY DIMM
• DL360G7 SRVR
4GB MEMORY DIMM
• DL360G7 SRVR
650 MAH RAID
BATTERY
Maintaining and Troubleshooting the HP ProLiant DL360 G7 Server
Task Reference
MSG: Removal and
replacement procedures:
• PCI riser board
assembly
• Expansion boards
• PCIe riser board
MSG: Removal and
replacement procedures >
Fan module
MSG: Removal and
replacement procedures >
DIMMs
MSG: Removal and
replacement procedures >
BBWC battery pack or
FBWC capacitor pack
Replacing internal components
Avaya
recommendation
Mark any cables
connected to the NIC
and reconnect to the
same ports after the NIC
is replaced.
The NIC requires a half-
HT faceplate. You might
need to remove the full
faceplate and replace it
with the half faceplate,
which requires a
crosshatch (Phillips)
screwdriver.
Note:
If adding a NICs:
populate PCI Slot 1
first, followed by Slot
2.
Refer to the Systems
Insight Display LEDs to
identify the defective fan.
Refer to the Systems
Insight Display LEDs to
identify the defective
DIMM.
Caution:
When removing the
air baffle, ensure that
the RAID battery does
not fall out of its
compartment in the
baffle.
Caution:
Refer to the
information on the top
of the air baffle and
inside cover for
correct DIMM
placement.
Caution:
Consult the internal
label with directions
for removing the air
baffle. Be careful that
the RAID battery does
November 2010 19