Advertisement
FMTPRR6 - Replacing FMTPFCT and FMTPMFCT Cleaning Reel
1. The cleaning reel should only be replaced in a clean and dust free environment. A contaminated cleaning reel may
cause damage to fibers.
2. Use a coin or
screwdriver to
loosen the screw
located on the front
of the FMTPFCT or
FMTPMFCT Fiber
Cleaning Tools.
4. Remove the
cleaning reel and
winding reel by
lifting them straight
out of the tool.
Remove the
cleaning tape from
the winding reel.
Do not discard the
blue winding reel.
6. Place the winding
reel and the
cleaning reel into
the tool and route
the cleaning tape as
shown on the
diagram located on
the tool cover.
8. Depress the green lever a few times and verify that the cleaning tape is advancing properly.
*MTP is a registered trademark of US Conec Ltd.
For Instructions in Local Languages
and Technical Support:
www.panduit.com/resources/install_maintain.asp
INSTALLATION INSTRUCTIONS PN433
3. Open and remove
5. Place the empty
7. Hook the cover on
www.panduit.com
Page 4 of 4
the cover using the
finger grip on the
side of the tool.
winding reel next to
the new cleaning
reel as shown.
Detach the
adhesive tape from
the cleaning reel
and attach to the
winding reel.
the tool body and
swing the cover
closed. Tighten the
screw.
Winding Reel
Cleaning Reel
Hooks
E-mail:
cs@panduit.com
Fax:
(708) 444-6993
Advertisement
