Onset hobo u30 User Manual page 39

2. Place Cables in Channel.
a. Hold the channel just below the HOBO U30 Station case (with the channel's hinged
side on the left and the taper facing in).
b. Open the channel and lay the cables and wires into the grooves.
NOTE: The solar panel or AC adapter cable must be in the leftmost (larger diameter)
groove.
NOTE: Use the small rubber plugs to fill any unused grooves. Center the thick part of the
plugs in the groove. Plug 'tails' can face in or out. It may be easier to install these after the
rubber cable channel has been pushed into the case. Insert the thin part of the plug into
the hole and pull to center the thick part of the plug in the channel.
3. Press the Channel into the Case.
a. Close the channel, making sure the cables, wires, and any plugs remain in their
grooves.
b. Press the channel into the opening.
To reduce the amount of excess cable in the case (especially when several Smart Sensors
are connected), gently pull the cables toward you as you press the channel into place.
Press the channel in until it is flush with the outside of the case. (When fully seated, the
channel will project slightly into the inside of the case.)
Onset Computer Corp
Figure 12: Place Cables in Channel
34