If A Problem Occurs; Specifications - Beamz 150.446 Instruction Manual

MODE 9:
Press the ESC button until
MODE 10:
Press the ESC button until
(default mode).
Stand alone-Mode
The units are not connected to a controller but can execute preset sequences that can be different from one
unit to the other. This mode applies to a single unit (MASTER) or for all units (Master-Slave). All units
need to have the same address n.1 "001". When the Master unit runs a programme, all other units will
follow. The programme cannot be applied to a Slave unit. It must always be applied to the Master unit.
(The controller must NOT be connected as this would corrupt the data and the stand-alone mode wouldn't
work properly).
N.B.: Make sure that a 120Ω resistor is connected to the input of the Master unit and the output of the last
Slave unit to ensure proper data transmission.

IF A PROBLEM OCCURS

If a problem occurs, following solutions might be helpful.
The units don't work
DMX problem
No unit reacts to the controller
Some units don't react
The shutter closes immediately
No light
Light goes on and off

SPECIFICATIONS

Type nr.................................................................... 150.446
Power supply ................................................. 230Vac/50Hz
Power rating................................................................. 50W
Dimensions ......................................... 177 x 177 x 250 mm
Weight......................................................................... 4.5kg
Fan .............................................................................12Vdc
Operating temperature ....................................... 5°C - 35°C
Minimum distance to:
Inflammable surfaces................................................ 50 cm
Other light effects ..................................................... 130cm
is displayed. Press ENTER to reset the system.
is displayed. Press ENTER to switch back to the standard mode
Fuse(s) blown / no mains power
Check the mains power – Faulty plug / lead
Check the wiring and connectors. Interchange units to eliminate the
problem. Check if the controller is faulty.
Faulty controller / XLR leads from the controller are faulty;
Check Controller OUT with unit 1-OUT
Bad data transmission/ Check 120Ω resistor / Wrong address / 1 unit
is faulty and disturbs the others / eliminate the problem by placing the
120Ω resistor into an other (preceding) unit / remove the connectors
from the suspicious unit and connect them together to find out if the
unit is really faulty.
The gobos have lost the index position. Bring the unit to your dealer
All Led's are faulty. Bring the unit to your dealer.
Unit is too hot. Check the fans, ventilation holes, lens
Subject to changes without prior notice