Table of Contents
Advertisement
Never try to disassemble or modify the module.
It may cause trouble, malfunction, injury or fire.
The module case is made of resin; do not drop it or subject it to strong
shock. A module damage may result.
Make sure to switch all phases of the external power supply off before
installing or removing the module to/from the panel.
If you do not switch off the external power supply, it will cause trouble or
malfunction of the module.
When disposing of this product, treat it as industrial waste.
(1) Tighten the module fixing screws and terminal block screws to those
torques specified below.
Do not over-tighten these screws. The screws and module case may be
damaged.
Module mounting screw
(M4 thread with finished circular flat washer)
Terminal block screw (M3 thread)
Terminal block mounting screw (M3.5 thread)
(2) When a DIN rail is used, install it taking care with the following.
(a) Applicable DIN rail type (conforming to JIS-C2B12)
TH35-7.5Fe
TH35-7.5A1
(b) Intervals of DIN rail mounting screws
Mount the DIN rail by fixing it with mounting screws at intervals of 200
mm (7.87inch) or shorter.
(3) To install the AJ65SBT-RPS/RPG module on the DIN rail, press, by the
finger, the DIN rail hook located on the underside of the module at the
centerline until you hear it click.
DIN rail
CAUTION
Screw location
DIN rail hook
Specified torque range (N/cm)
15
78 to 108
59 to 88
68 to 98
Advertisement
Table of Contents
