Panasonic AJ-HD3700AP Operating Instructions Manual page 13

2K error messages
Error messages in the 2K system mode are added. In the event of an abnormal condition, an error message is
displayed in the window of the unit. In this case, follow any instructions included in the description.
If any errors are generated, the front LED (ALARM, 2048 or 1920) of the AJ-HDP2000 lights or blinks (at normal
speed or high speed).
Message
2K FAN STOP
2K NO REMOTE
RECORDED FORMAT UNMATCH (NO J2K TAPE)
RECORDED FORMAT UNMATCH
RECORDED RATE UNMATCH OUTPUT FRAME
FREQUENCY
CONCEAL V IN 2K
NO SERIAL DATA INPUT FROM HDD5
NO 2K FORMAT SERIAL DATA INPUT
CRC ERROR IN SERIAL DATA INPUT FROM
HDD5
NO EXTERNAL HD REF IN 2K
* If any warnings are generated while ERR/FMT or ERR are set in TC/CHR menu F13
(EX SUPER), "2K PROC ERROR" is displayed on SUPER of the Monitor OUT output.
F1 F2 F3 F4
Error description
The fan for the AJ-HDP2000 stops.
(Contact the nearest dealer.)
Rear SERVICE SW of the AJ-HDP2000 is not in
the OFF position.
TAPE is not compressed in J2K format.
There is a mismatch between SYSTEM
FORMAT of the unit selected in settings and
FORMAT of TAPE. (2048/1920, XYZ/RGB)
There is a mismatch between the output frame
frequency and the frame frequency recorded on
the tape.
An error occurs in 2K reproduction data and
the CONCEAL function works.
Compressed SERIAL DATA (HD SDI) from
AJ-HD3700B/A/H main unit is not linked.
In 2K SYSTEM mode, the compressed SERIAL
DATA from AJ-HD3700B/A/H main unit is not a
J2K compression signal.
A CRC error occurs in SERIAL DATA (HD SDI)
signals from AJ-HD3700B/A/H main unit to
AJ-HDP2000.
HD REF IN is not connected.
Signals other than 1920 a 1080 (HD) tri-level
sync signal are transmitted to HD REF IN.
- 13 -
F5 F6 F7 F8
AJ-HDP2000
ALARM LED
: Lighting
: Fast Flashing
: Flashing
: Flashing with some setting
F13
F12
F11
F10
F9
2048 or 1920
LED