Battery Inspection & Care - NewMar torrey pine 2008 User Manual

Battery Inspection & Care
WARNING
Remove rings, metal watch bands and other metal jewelry before working
around batteries. Use caution when using metal tools. If a tool contacts a battery
terminal or metal connected to it, a short circuit could occur which could cause
personal injury, explosion or fire.
WARNING
Use caution when working on top of your vehicle. The wet roof membrane may
be extremely slippery.
IMPORTANT
Do not use solvents such as acetone, MEK, toluene, etc. on the decals. Any
solvent including alcohol may soften or smear colors. Do not use lacquer thinner
or paint on decals. Do not overcoat the decals with clear paint. Do not allow
gasoline or other fuels to drip or stay on the decals for any length of time. If this
occurs, immediately flush the area with water.
Remember, when a battery is not used for an extended period of time, it may
lose its charge. Periodic charging of the battery during storage of the unit will
increase the life of the battery. Check the external condition of the battery
periodically. Look for cracks in the cover and case. Check the vent plugs and
replace them if they are cracked or broken. Keep the battery clean.
Accumulations of acid film and dirt may permit current flow between the
terminals, which could drain the battery. To clean, wash the battery with a
diluted solution of baking soda and water to neutralize any acid present. Rinse
thoroughly with clean water. Foaming around the terminals or on top of the
battery is a sign that acid is being neutralized. Avoid getting the baking soda
solution in the battery. Secure all vent caps. Dry the battery cables and
terminals. Do not use grease on the bare metal inside the cable terminals to
prevent corrosion. Grease can act as an insulator. Electricity will not flow
through it. A plastic ignition spray will protect the terminals after they have
been cleaned.
9:6
2008 Torrey Pine Fifth Wheel by Newmar