Indicator Light - O3 PURE LS Owner's Handbook Manual

Alarm
Your O3 Pure LS unit is equipped with an internal leak detector. If a leak happens to
develop inside of the unit, water will accumulate on the bottom panel. The sensor will set
off an audible alarm and will automatically turn the unit off. This alarm will continue to
buzz until the leak is stopped and/or the unit is unplugged. If this alarm should occur,
you should unplug the unit, turn off the cold water valve and call your distributor for
assistance.

Indicator Light

The Indicator light, viewed through the window on the front of the O3 Pure LS unit, as
two states of operation. (Fig. g)
A blue light indicates the normal operating condition of O3 Pure LS unit. (g.1)
A flashing red light indicates that the fan or the active oxygen generator is not operating
properly. Please contact your distributor for service. (g.2)
The use of your O3 Pure LS unit is very easy and convenient. As long as you install your
O3 Pure LS properly, you simply operate your washer according to the instructions pro-
vided by the manufacturer. O3 Pure LS is designed to automatically turn on as soon as
the washer demands water for the wash cycle and again for any rinse cycles. The only
differences are that you ONLY USE THE COLD WATER setting for both the wash and
rinse cycles on your washer.
Note: If hot water is used it dilutes and defeats the effectiveness of the enhanced and
Photo Catalytic Oxidizers that the O3 Pure LS unit has introduced into the wash water.
We suggest that you pre-treat stains, just as you would without an O3 Pure LS unit. For
normal soiled laundry, you should only need a very small amount of detergent or none at
all.
You can easily tell if your O3 Pure LS unit is operating properly by looking through the
viewing window. The viewing window glows blue and you can see the production of en-
hanced oxidation bubbles in the tube through the window when the water is flowing
through (you can actually see it working)! If you do not see bubbles during the water input
cycles, please ensure that you have the correct O3 Pure LS unit for your washing ma-
chine (see model selection on the next page). When the water stops flowing, the O3 Pure
LS will automatically turn off following a short cool-down period.
Page 5
Alarm & Indicator lights
Using Your O3 Pure LS
How to tell your O3 Pure LS unit is working?
Copyright © 2011 Kel Technologies - All Rights Reserved
Daily Use
Stains