Specifications - Progressive Dynamics PD2020 Owner's Manual

Series Connection:
Wiring the Intelipower chargers as shown below will provide a combination of 12
and 24 volt charging system. This can eliminate the need to install expensive battery
equalizers and additional chargers for the 12 volt house and 24 volt bow thruster
batteries.
- +
Engine # 2
12 Volt Battery
+ -
Engine # 2
12 Volt Battery
+ - + -
Bow Thruster Bow Thruster
12 Volt Battery 12 Volt Battery
The Series system shown above will provide 24 volt charging for the bow thruster and
engine batteries while supplying 12 volt charging for the house battery.
- +
Output Voltage = 24 Volts
Engine # 1
12 Volt Battery
1
2
Inteli-Power
Charger 1
3
+ -
GND
Engine # 1
12 Volt Battery
Output Voltage = 12 Volts
1
2
Inteli-Power
Charger 2
3
GND
- +
House
12 Volt Battery
-13-
Do not replace the converter unless the following checks have been performed:
1. Loosen the screw on all the positive terminals and disconnect the positive wires.
Read the converter output voltage using a DC voltmeter. If the voltage is above 13
volts, the converter is working properly.
2. If the converter output is zero volts, use an AC voltmeter to check for proper voltage
on the 120 VAC power source. This voltage should be between 104 and 130 volts.
3. Check the fuse(s) located next to the output terminal block inside the converter. The
fuse(s) will only blow if the battery or DC output leads were connected in reverse,
even for a moment. Replace the fuse(s) and repeat step 1.

SPECIFICATIONS

PD2020
Input: 105-130 VAC 50/60 Hz
350 Watts
Output: 13.6 VDC, 20 Amps
Dimensions: L= 10.2" W= 7.8" H=4.2"
Weight: 6lbs
PD2030
Input: 105-130 VAC 50/60 Hz
550 Watts
Output: 13.6 VDC, 30 Amps
Dimensions: L= 10.2" W= 7.8" H= 4.2"
Weight: 6.25lbs
PD2060
Input: 105-130 VAC 50/60 Hz
1000 Watts
Output: 13.6 VDC, 60 Amps
Dimensions: L= 10.2" W= 7.8" H= 4.2"
Weight: 6.5lbs
©2002 Progressive Dynamics, Inc. All rights reserved. Quiet Sensor is a registered
trademark of Progressive Dynamics, Inc.
PATENT NUMBERS 5,600,550, 5,687,066, 5982,643 and 6,184,649.
PD2040
Input: 105-130 VAC 50/60 Hz
650 Watts
Output: 13.6 VDC, 40 Amps
Dimensions: L= 10.2" W= 7.8" H= 4.2"
Weight: 6.25lbs
PD2050
Input: 105-130 VAC 50/60 Hz
900 Watts
Output: 13.6 VDC, 50 Amps
Dimensions: L= 10.2" W= 7.8" H= 4.2"
Weight: 6.5lbs
PD2080
Input: 105-130 VAC 50/60 Hz
1300 Watts
Output: 13.6 VDC, 80 Amps
Dimensions: L= 10.2" W= 7.8" H= 4.2"
Weight: 8.8lbs
-14-