DISASSEMBLING PROCEDURES (CD) -7
CD MECHANISM : REPLACEMENT OF DRIVE BELT
[Notes of re-assembly]
Check the lever position is at the left end.
1
Confirm the position of marking, when attaching the
2
gear (Gear and Loading).
-- Top side view--
Top side
Move to left end.
Marking
Front side
Attach the Tray Table disk-C
3
-- Top side view--
[NOTES]
Even if the tray closes completely, the lever does not
move to right end.
Therefore, move the lever to right end by hand.
Check the marking on the opposite side of the gear
4
and the position of
mark are in agreement.
--Bottom side view--
FR-N3X
Front side
Marking