J.P. Instruments EDM-730 Pilot's Manual page 69

Filled Tanks
Note: if 'FILL? N' is visible, start
at '4.':
1. Hold both STEP and LF until
the display shows PROGRAM
followed by
FUEL? N
Tap LF to see
2. FUEL? Y
3. Tap STEP.
. Tap LF to see
4. See FILL? N
*
FILL 75
With aux tanks or tabs, tap LF
5.
again to see
FILL 120*
Tap STEP to accept.
6.
Added or Removed Fuel
Note: if 'FILL? N' is visible, start
at '4.':
1. Hold both STEP and LF until
the display shows PROGRAM,
followed by
FUEL? N.
2. Tap LF to see
FUEL? Y
Tap STEP.
3.
. Tap LF 2 or 3
4. See FILL? N
times to see .
FILL+
Tap STEP and see
5.
Hold LF to increase or tap LF
6.
to decrease the amount of fuel
displayed.
Tap STEP to accept.
7.
Reset an Alarm

Temporary reset (next 10
minutes): tap STEP.

Reset for remainder of flight:
hold STEP until the word
appears.
For Your Safe Flight
Leaning Rich of Peak
1. Pre-lean mixture and wait one
minute.
2. Tap LF (if you see
both STEP and LF until you
,
. see
. 3. Lean mixture until you see a
column flash and the words
LEANEST
1545 SET
4. To see the peak EGT of the
first cylinder to peak and fuel
flow :
hold LF.
5. Enrich mixture to set desired
temperature.
Leaning Lean of Peak
1. Pre-lean mixture and wait one
minute.
Tap LF (if you see
2.
.
both STEP and LF until you
see
3. Lean mixture until you see
inverted columns.
.
.0 GAL
4. Continue leaning until column
flashes and the word
appears. Temp dif below peak
of the last cylinder to peak and
the fuel flow now appear.
5. To see the peak EGT of the
first cylinder to peak and the
delta fuel flow (GAMI spread),
hold LF and see
OFF
6. Lean mixture to set desired
temperature.
*
Values may vary depending
on your installation.
old
LOP, h
.
ROP)
followed by
*
*or *,
1560 PK 1560 13.5
old
ROP, h
LOP).
RICHEST
1560 1.0 *.
Page 69