Page 1
User Guide FlashBack-3 Covert Video Recorder FlashBack-3C H.264/AVC Single & Dual SD Card Recorder Version 4 User Guide Ovation Systems Ltd. Springfield Barn London Road Milton Common Oxfordshire OX9 2JY Tel: +44 1844 279 638 Fax: +44 1844 279 071 Email: support@ovation.co.uk...
(page 28) 1.1 Introduction FlashBack-3C is a miniature DVR / video streamer designed for covert surveillance operations in the FlashBack-3 product line. The FlashBack-3C has Ovation's I-Conex connectors on the rear of the unit; I-Conex includes a selection of cable assemblies that interface to commonly used power, video and audio connectors.
Optional internal battery with charger. 1.2 Support, Latest Updates and Information: Ovation Systems website includes a Secure User Area with the latest software updates, data sheets, user guides etc. for download. To gain access, please email support@ovation.co.uk with the serial number of one of your units, together with your name and organisation.
TIP► Any cable may be lengthened by the in-line extension cables provided. On the FlashBack-3C Single, the brown / blue connector has a dual function of either Ethernet or RS232 interface, which is auto-switched depending upon which cable type is connected (feature enabled from FB3 serial number 3751 onwards).
Page 6
(Video 1) Audio Right (Video 2) Long Extension 1M Male to Female Extension x 1 Short Extension 0.5M Male to Female Extension x 1 500mm Figure 4: FlashBack-3C Single I-Conex Cable Set Issue: 4.7.2134-2 Ovation Systems Ltd Page 6 www.ovation.co.uk...
Covert Video Recorder 2.2 FlashBack-3C Dual The FlashBack-3C Dual has additional connectors including; dedicated RS232 and Ethernet ports, separate record control and DC power inputs, and an audio and video monitor output port. See Figure 5 and Figure 7, page 8.
Page 8
Audio Out Right 200mm 100mm Red /(Brown) - Record OK Control Green - Rec Ctl 2 Blue - Rec Ctl 1 Braid /(Black) - Ground 1.5m Figure 7: FlashBack-3 Dual I-Conex Cable Set Issue: 4.7.2134-2 Ovation Systems Ltd Page 8 www.ovation.co.uk...
The external switches / triggers. There are two external control inputs for the FlashBack-3C; “Record Control 1” (Blue cable) and “Record Control 2” (Green cable). By default “Record Control 1” is configured to record when connected to Ground (i.e. a record switch input) and “Record Control 2”...
User Guide FlashBack-3 Covert Video Recorder 2.5 I-Conex Peripherals There is a range of I-Conex peripherals available for the FlashBack-3C range including miniature low light cameras, Knowles microphones, GPS receivers etc. Bullet Camera Miniature 12V Bullet Camera Knowles Microphone (pair)
It is powered via the same connector which is enabled via the “Connectivity” web page (Section 7.9, page 27). The RS232 interface can also control an external PTZ when used with FindMe, Ovation’s PC device manager software. Visca and Pelco-D protocols are supported which are set in the “Connectivity”...
Format is complete when the status LED stops fast flashing red. (Operate button with Format / a ballpoint pen or similar) reset to defaults Front panel button. Figure 10: FlashBack-3 Front Panel Format Button Issue: 4.7.2134-2 Ovation Systems Ltd Page 12 www.ovation.co.uk...
Long red with blink: no video present AND media full or not present. Fast flashing red: media format or error. Permanent fast flashing red / green: system error. Seconds = No LED Figure 11: Status LED Function Issue: 4.7.2134-2 Ovation Systems Ltd Page 13 www.ovation.co.uk...
Press and hold the [Stop] button for 5 seconds, until the unit enters its low power mode and the Status LED goes out. NB► When the unit is switched off with power connected (or with a charged internal battery) the Status LED briefly flickers red/green every 8 seconds. Issue: 4.7.2134-2 Ovation Systems Ltd Page 14 www.ovation.co.uk...
Release the button as soon as status LED on the new drive becomes active. It is also possible to swap cards remotely the via the FindMe and webpage interfaces. Issue: 4.7.2134-2 Ovation Systems Ltd Page 15 www.ovation.co.uk...
4.2 Playing with Microsoft Media Player Microsoft Media Player requires a plug-in to play FLV files. K-Lite Codec pack is recommended (see www.codecguide.com) which is available for download from the Useful Applications Folder of Ovation’s secure site www.ovation2.couk Issue: 4.7.2134-2...
+35ºC (95ºF). To install the battery into a FlashBack-3C: 1. Disassemble the FlashBack-3C by unscrewing the four screws in the base plate of the unit. 2. Attach the battery to the new base plate using the supplied tape, see Figure 14.
The Wizard only changes a small number parameters. If there’s any doubt about the state of the unit, a reset to defaults (see page 15 Section 3.8) is recommended before you load the “settings” file. Figure 16: FlashBack-3 Configuration Wizard Issue: 4.7.2134-2 Ovation Systems Ltd Page 18 www.ovation.co.uk...
The Wizard can be used to set a static IP address by checking the “Network connection + server setup” option on the start page (see Section 6Error! Reference source not found., page 18) Issue: 4.7.2134-2 Ovation Systems Ltd Page 19 www.ovation.co.uk...
1 second loss in video). Recording is controlled via the “Record start” and “Record stop” buttons. The “Stream start” and “stream stop” control functions require a Server and Ovation’s FindMe viewing software to be setup and installed, see Section 9, page 31.
However, right-click “Save link as...” is preferred as downloaded the file without attempting to play first. TIP► Ovation Systems FindMe PC application provides an enhanced list of files with a time- line showing motion activity, alarms etc. (see Section 9, page 31). 7.5 Alarm List Page This is a chronological list of alarm events generated from the triggers set-up via the "Basic...
1000 by clicking [Advanced] Audio Source : "Int Mic" uses the internal microphone. "Line" is a high level audio input, and "Ext Mic" is for use with external microphones. Issue: 4.7.2134-2 Ovation Systems Ltd Page 22 www.ovation.co.uk...
FlashBack-3 into standby until the first timer event. The "Custom" timer mode is where the action(s) of the timer are beyond just "Record" or "Wakeup" and set by the Expert Trigger page. Issue: 4.7.2134-2 Ovation Systems Ltd Page 23 www.ovation.co.uk...
Page 24
Audio Detection operates in a similar manner to video. The higher the audio threshold value the fewer triggers. The default audio threshold is -12dB and after adjustment click the corresponding [S] button to store. Issue: 4.7.2134-2 Ovation Systems Ltd Page 24 www.ovation.co.uk...
A red tick is also available (), this is only required for triggers which work in reverse, i.e. external triggers which are active when open, rather than active when closed. TIP► The list of possible trigger inputs shows inputs which are currently active in green, inactive in red. Issue: 4.7.2134-2 Ovation Systems Ltd Page 25 www.ovation.co.uk...
Page 26
Raise Alarm Trigger Action can be configured to capture a snapshot (JPEG), via "Video Setup" on the "A/V Setups" webpage, see above. Alarm snapshots are then included in the "Alarm List" webpage and the FindMe timeline. Issue: 4.7.2134-2 Ovation Systems Ltd Page 26 www.ovation.co.uk...
500 mA at 5 V, 200 mA at 12 V (approx). GPS Power: GPS power at 5 or 3V with maximum current of 500mA. GPS receiver pucks provided by Ovation require a 5V supply. RS232 Function: PTZ: Control external PTZ camera. When selected, the baud rate PTZ protocol and whether the camera is capable of simplex or duplex data.
> "On Screen Display" >"Date format". Inactivity Timer: sets the time of inactivity before the unit will go to sleep. Useful for battery operated systems to save power when not recording. Issue: 4.7.2134-2 Ovation Systems Ltd Page 28 www.ovation.co.uk...
The [Defaults] button resets all the FlashBack-3 parameters including IP address to DHCP / static of 192.168.0.123. Issue: 4.7.2134-2 Ovation Systems Ltd Page 29 www.ovation.co.uk...
5. Wait unit the LED shows static red (about 2 minutes). 6. Re-boot. Upgrade is now complete. 8.2 Ethernet upgrade It is possible to upgrade the FlashBack-3 via the Ethernet port via the FindMe Ovation Device Manager. Please refer to the FindMe user guide available from Ovation's Secure User Area.
From FlashBack-3 firmware version 3 onward, the preferred method of connecting to remote devices located on a LAN or the Internet is via a PC application called FindMe, Ovation’s Device Manager. FindMe lists all your active FlashBack-3 devices. It is then easy to select the required unit, open its webpage, stream live video or download video recordings to your PC from a time-line of motion activity.
Need help?
Do you have a question about the FlashBack-3C and is the answer not in the manual?
Questions and answers