Faults And What To Do About Them - Siemens WT45H200GB Installation And Operating Instructions Manual

3

Faults and what to do about them

F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
ð on the display panel
and drying has been inter-
rupted.
ñ on the display panel.
ñ on the display panel
even though the fluff filter
and the EasyClean filter
have been cleaned.
Dryer will not start.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
* Depending on the model
Cause/remedy
Empty the condensate container and press the Start button.
■
If the optional condensation drain has been installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and flush the hose out.
Make sure that the hose does not have any kinks when it is in place.
Clean the fluff filter ~ Page 28 and the EasyClean filter ~ Page 31.
It is important to proceed in the order set out in the section entitled
~ Page 31.
Note: The appliance must be switched on when it is cleaned.
Start button selected?
■
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Is the childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay.
■
Creasing occurs when you have exceeded the maximum permitted load or
■
selected the wrong programme for the type of fabric. All the required infor-
mation can be found in the programme table.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Faults and what to do about them
en
33