Cleaning The Moisture Sensor; Cleaning The Easyclean Filter - Siemens WT45H200GB Installation And Operating Instructions Manual

Cleaning the moisture sensor

The dryer is equipped with a
Note:
stainless-steel moisture sensor. The
moisture sensor measures how damp
the laundry is.
After long periods of usage the moisture
sensor may become covered by a fine
layer of limescale or residues of
detergents and care products. Such
residues must be removed regularly as
the sensor function and in consequence
the drying result may be impaired.
Open the door and clean the moisture
sensor with a coarse sponge.
Caution!
Moisture sensor may be damaged.
Do not clean moisture sensors with
abrasives and steel wool.

Cleaning the EasyClean filter

When ñ appears in the display panel,
clean the EasyClean filter as follows:
The appliance must be switched on.
First clean the fluff filter ~ Page 28.
1.
Close the door of the dryer.
2.
Open the maintenance flap on the
3.
heat exchanger.
Release the levers on the EasyClean
4.
filter.
Use the grip handle to pull the
5.
EasyClean filter out.
Now take off the filter mat.
6.
Wash out the filter mat by hand
7.
using clean water.
Notes
– If the filter mat is covered with
stubborn dirt, you can also
remove this carefully using a
vacuum cleaner.
– Do not use cleaning agents.
Dry the filter mat by squeezing the
8.
water out.
Only use the filter mat if it is
Note:
clean and dry.
Put the filter mat back on.
9.
Ensure that the filter mat is
Note:
not misshapen, torn or clogged.
Position the filter mat as shown
above.
Cleaning
en
31