GE JHP61GJ Use And Care Manual page 32

Hug-h W-face Wits
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, the plug-in surface
units are removable.
I
Terminals
T{)
remove:
Be sure the control for the surface
unit is on OFF and the coils are cool
before removing the Calrod@ unit.
Raise the unit coil opposite the
receptacle. Lift about one inch
above the trim ring and pull away
from the receptacle.
After removing the plug-in surface
unit, remove the drip pan and trim
ring to clean under the unit.
To clean:
Wipe around the edges of the
surface unit opening in the range
top. Clean the area below. Rinse
all washed areas with a damp cloth
or sponge.
To
replace:
Place drip pan in the surface unit
cavity found on top of the range.
Line up the drip pan so the unit
receptacle can be seen.
Insert the terminals of the plug-in
unit through the opening in the drip
pan and into the receptacle.
Guide the surface unit into place
so it fits evenly and locks snugly
into the receptacle or trim ring.
Note: The drip pan must be under
the trim ring.
Do not attempt to clean, adjust,
or in any way repair the plug-in
receptacle. If liquid should spill
and collect inside the receptacle,
call for service.
,- --
w.'
.&'
32