Panasonic PT-AE7000U PT-AT5000E PT-AE700EA PT-AE7000EH Service Manual page 40

SECTION 4
< Schematic Diagram >
PT-AE7000U / AE7000EA / AE7000EH
Model No.
PT-AT5000E
CONTENTS
1. BLOCK DIAGRAM ・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・
1.1. Signal Processing
2. INTERCONNECTION BLOCK DIAGRAM ・・・・・・・・・・・・・・
3. SCHEMATIC DIAGRAM
3.1. A -P.C.Board (1/3)
3.2. A -P.C.Board (2/3)
3.3. A -P.C.Board (3/3)
3.4. S / V / L -P.C.Board
4. CIRCUIT BOARDS DIAGRAM ・・・・・・・・・・・・・・・・・・・・・・・・
4.1. A -P.C.Board (Component Side)
4.2. A -P.C.Board (Foil Side)
4.3. S / V / L -P.C.Board
DIA-2
DIA-3
・・・・・・・・・・・・・・・・・・・・・・・・・・・・・・
DIA-4
DIA-8
Important Safety Notice
Components identified by the intemational symbol
When replacing any of these components, use only the manufacturer's specified ones.
■Notes
1. Resistor
All the resistors are carbon 1/4W resistors, unless marked as follows.
The unit of resistance is an OHM [Ω] (K=1 000 M=1 000000).
: Nonflammable
: Solid
: Wire Wound
2. Capacitor
: Temperature Compensation
: Polyester
: Metalized Polyester
: Polypropylene
3. Coil
The unit of inductance is a H, unless otherwise noted.
4. Test Point
: Test Point
5. HOT and COLD indications
The power circuit board contains a circuit area using a separate power supply to isolate the ground connection.
The circuit is defined by HOT and COLD indications in the schematic diagram. Take the precautions below:
6. This schematic diagram is the latest at the time of printing and the subject to change without notice.
■Precautions
1. NEVER touch the HOT part or the HOT and COLD parts at the same time, or you may get an electric shock.
2. NEVER short-circuit the HOT and COLD circuits, or the fuse may blow and the parts may break.
3. NEVER connect an instrument such oscilloscope to the HOT and COLD circuit simultaneously, or the fuse may blow.
Connect the ground of instruments to the ground of the circuit being measured.
4. MAKE SURE to unplug the power cord from the power outlet before removing the chassis.
5. When ordering parts, please check the part number of the "Replacement Parts List".
have special characteristics important for safety.
: Metal Oxide
: Metal Film
: Fuse
: Electrolytic
: Bipolar
: Dipped Tantalum
: Z-Type