All Models; Before You Start - Danfoss rt51 Installation Instructions Manual

All models

GB

Before you start

To reset the unit, open the flap on the
front of the programmer. Remove the
batteries for  minutes, then replace.
The display will automatically default to
DAY mode (d shown top left of display)
and show actual temperature in the large
20.0
C
characters and required temperature in
22
the smaller characters.
Setting the DAY & NIGHT temperatures
DAY temperature
Use the s and t buttons until the
required DAY temperature is shown.
NIGHT (set-back) temperature
Press s and t buttons together once to
select NIGHT mode (n shown top left of
display).
Use the s and t buttons until the
required NIGHT (set-back) temperature
20.0
C
is shown (between 5-30°C or Off ).
22
10